Shut off the main water source to the water filtration system and the RV.
Turn on and leave on the cold kitchen faucet to release the water pressure from the water filtration system.
Pull up the locking clip at the front of the filter housing.
Use the wrench included to turn the filter housing left to loosen and remove it.
Remove the filter insert shrink wrap and place the filter insert inside the filter housing.
Turn right the filter housing to tighten in position and push down the locking clip to secure it.
Repeat steps #3-6 for the other stages of a multiple-stage filtration system.
Turn on the main water source to the water filtration system and the RV.
Run the water through the filtration system and flush for 5 minutes.
Turn off the cold kitchen faucet.
Brinkley CLM4 Winterizing Instructions
DO NOT ALLOW FILTER HOUSING TO FREEZE!
Remove the filter insert before using anti-freeze to winterize the system.
Reinstall the empty filter housing back on the filter head/cap.
Proceed to winterize coach.
Flush filter housing thoroughly before it is put back into service after winterizing.
For best results, replace the filter insert seasonally.
Flush the new filter insert for approximately 5 minutes to remove any carbon particles.
Do not use filters where water is microbiologically unsafe or of unknown quality.
Maximum operating pressure is 100PSI/0.7Mpa
Maximum operating water temperature is 100°F/38°C
Filtration System Flow Rate and Timing for Filter Change
The initial filtration system flow rate throughout- 2.64 GPM/10 LPM range at 45 psi/0.31 MPa incoming pressure. The flow rate decreases as the filter does its job and becomes clogged with the trapped impurity. The rate of decrease varies by water quality from place to place. When the flow rate decreases noticeably, it is time to replace the filter to maintain optimal water quality and the best user experience.
We use cookies to analyze website traffic and optimize your website experience. By accepting our use of cookies, your data will be aggregated with all other user data.